Hello, guy's welcome to another article, in this article we are going to discuss How to repair corrupted or unmounted Pendrive with windows. let's start.
If you have been using USB flash drives, you might be familiar with some of these error messages.
- USB device not recognized
- Windows do not recognize it.
- Unknown drive, port reset failed
- Descriptor request failed, error code 43
- Drive did not load successfully. Etc.,
How to repair Pendrive?
Step 1:
First, you Connect your corrupted pen drive or sd card to your computer.
Step 2:
Now open your command prompt with administrator.
Step 3:
Once you open a command prompt. you type this below command.
diskpart
Step 4:
Now you type this below command. this command will help you to list all the storage connected to your computer.list disk
Step 5:
Now you choose your sd card or pen drive disk number NOTE: Make sure you enter the number correctly. Otherwise, you may format your internal hard drive. You can type the list disk again to check whether you are going correctly. There will be a star (asterisk symbol) before the name of the selected disk.
Select disk (no)
Step 6:
Now you type this below command. this command will help you to clean your partition.
clean
Step 7:
After executing the clean command type the below command. This command will help you to create your partition into primary.
create partition primary
Step 8:
Now you type the below command
active
Step 9:
Now you choose partition so type this below command in your command prompt.
select partition 1
Step 10:
Now you type this below command. this process will take a few minutes. You can write NTFS instead of fat32 if you want to carry less larger than 4 gigabytes. Don’t close the CMD
formate fs=fat32
Post a Comment